Laser centering
The laser centering is directly installed on the assembly head. The component which has to be centered is while rotating measured by the laser centering. Its shadow on the opposite side is analysed and a contactless fast centering happens. The component capability ranges from 0201 chips up to components with dimensions of 32 x 32 mm and Fine Pitch to 0.4 mm at PA520.
BGAs can be centered in this way, too.
The laser centering is also a method to determine the component dimensions like length, width and height.
smartFEEDER
smartFEEDER are intelligent feeders, that are equipped with a microprocessor control. Using a wireless barcode reader, reel- and feeder-barcode are programmed and saved in the software. The placeALL® Pick & Placer has now knowledge about the amount, type and position of the feeder. Thus changeover times between different projects are greatly reduced.
Automatic fiducial recognition
This extension recognizes the fiducials on a circuit board by itself. This is especially useful for a smartLINEsystem. The position correction is done using a dot, cross, rhomb etc. on the circuit board.
While assembling multi-boards, single circuit boards - which are marked by the producer - can be excluded.
Teach In
If no CAD data is available to create a new assembly project, each position can be teached in manually.
Therefore the component is displayed and aligned virtually. After reaching the right placing position on the monitor, it is approved and automatically added to the assembly project.
CAD data converter
With the universal CAD data converter, you can import data from all common CAD programs in a few simple steps.
To ensure a high machine load on the Pick & Placer, the corresponding data files can be prepared using our offline software version on a separate workstation.
Dispensers
Dispensing of solder paste or glue can be done with two different systems:
- Time-pressure system
For dispensing big solder paste dots or glue
- Microprocessor-controlled system
This system detects parameters like cartridge temperature, fill level etc. .By this Fine-Pitch components down to a pitch of 0.5 mm can be safely dispensed, the ideal solution for prototypes!